Lubrication & Maintenance; Headlights - Goldacres Crop Cruiser G6 Operator's Manual

LUBRICATION & MAINTENANCE

Headlights

The headlights use an HB3 globe type globe. To
replace the globe, the bonnet will need to be
unclipped on both sides and rolled forward. Do not
let the bonnet roll forward under it's own weight.
Lean over the cold engine and unclip the loom
from the globe and then unclip the globe from the
headlight housing and remove. Replace with new
globe and follow the instruction in reverse. Ensure
bonnet has been re-clipped before driving.
Headlight alignment can be made by adjusting the
three screws located around the headlight body.
Make a change and then check to see the movement
was in the correct direction.
SERVICE ITEM
Headlight globe - Low beam
Headlight globe - High beam
G4.7, G5, G6 Crop Cruiser Operator's Manual MY19 - REV 0
Chapter 10
Adjustment screws
PART NO. -
GOLDACRES
GA3000082
GA3000082
Chapter 10 - Lubrication & Maintenance - 117
Adjustment screw
PART NO. -
GENERIC
HB3 12V 60w
HB3 12V 60w