Table of Contents
Advertisement
2
Flow ontrol Flow Meter
Flow ontrol al e
The flow control valve regulates the flow going
DESCRIPTION
DATE - INITIAL
to the boom sections directed via the console. It
REVISIONS
controls the flow to the boom by regulating the
2
amount of liquid that bypasses back to tank.
The flow control valve is a positive ball valve which
means it can control flow infinitely to the boom
from 0 L/min to the maximum pump output,
dependant on system pressure.
ate ontrol Mo
The Raven Rate Control Module (RCM) may be
fited as an option. It is mounted to the boom
centre if fitted. Consult your Raven RC
manual supplied for detailed setup and calibration
information.
18 - Chapter 6 - Calibration
3
4
UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE
IN MILLIMETRES
ECN N°
THIS DRAWING REMAINS THE PROPERTY
OF GOLDACRES TRADING PTY LTD AND IS
SUBJECT OF COPYRIGHT
3
4
le
operation
5
pee
Flow control
valve is located
on the left
hand chassis
rail (between
the pod and
induction
hopper).
The flow control valve can be operated in manual
UNTOL. DIMENSIONS
Material
:
OPEN DIM
± 1.00
mode from the console for boom priming, flushing
ANGULAR
± 0.50°
Surface Finish:
UNLESS OTHERWISE
TOLERANCED
DRG. STANDARD
and also troubleshooting.
/PRACTICE
DEBUR ALL EDGES
AS 1100
M
6
en or o ation
Flow meter located on
top of centre (between
centre level ram and
Norac cylinder).
Wheel speed sensor located
behind wheel on axle (right
hand side wheel). Smart steer
speed
angle sensors are fitted
here when optioned.
TITLE:
Drawn By:
DWG NO.
Luke M
24/05/2010
Prairie Pro 8500L 2017
Drawing Checked:
Approved
DATE EDITED:
NealHarvey
19/06/2017
SCALE:1:35
Continued over page
Prairie Pro Operator's Manual MY19 - REV 2
7
8
1-3 MOR
GOLDACRES
MITCHE
PH: 03 5
FAX: 03
DO NOT SCALE DRAWING
FINISHED WEIGHT:
R
K
Advertisement
Table of Contents
