Connections Of Parts - NEC Flash Memory Programmer PG-FP3 User Manual

2.3 CONNECTIONS OF PARTS

This section explains how to connect the various parts of the PG-FP3.
The PG-FP3 can be used in two ways. It can be connected to a host machine and controlled by application
software or it can be used in stand-alone mode without being connected to a host machine. When using the PG-FP3
without being connected to the host machine (i.e., in stand-alone mode), you may skip the description on connection
with the host machine.
Remark When the PG-FP3 is used in stand-alone mode, interfacing with the target must be specified in advance.
To do so, select the device to be used and the communication mode using the application software on
the host machine. The setting information is recorded in the PG-FP3. In stand-alone mode, the PG-FP3
interfaces with the target based on this information.
22
CHAPTER 2 CONFIGURATION
Photo 2-1. Connections (Host, PG-FP3, and Target)
User's Manual U13502EJ2V0UM00