Hyundai Body Builder 2015 Manual page 78

INTRODUCTION PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION
- A minimum clearance between the wheel and wheel wells must be respected:
MINIMUM DISTANCES OF THE WHEEL WELL FOR PANEL VAN
Permissible gross vehicle
weight
3.5 t
4.1 t
4.6 t ~ 5.0 t
1 Contour of standard panel van wheel well
Fig. 4-53 LCV_SPBTC43_002 Minimum distances of the wheel well for panel van
At all events, the distance between the wheel wells and the wheel must be sufficient
to allow the correct operation of the vehicle and its components.
WARNING
Doors that incorporate safety elements such as airbag sensors cannot be modi-
fied, since this could affect the proper performance of these systems during a
crash, preventing the protection of the occupants of the vehicle.
NOTICE
- The space needed to mount snow chains must be taken into account, even if
the suspension elements are compressed to the maximum.
- To obtain more information about wheel wells,
see Chapter 2.3.7 "Wheel dimensions and clearances".
- For more information about wheels and mudguards
see chapter 4.12.4 "Mud guards".
- For more information on wheel modifications
see chapter 4.14 "Axle and wheel modifications".
78
MAINTENANCE AND DAMAGE PREVENTION
POWER TAKE-OFF
Tyres
235/65R16
235/65R16
2 x 195/75R16
a Minimum distance frame flange to wheel well
Body Builder Manual Part II, Specific Book LCV
ELECTRIC AND ELECTRONIC SYSTEMS
Dimension (a)
(mm)
238
245
215
WORK ON BASIC VEHICLE
APPENDIX
V1.0, February 2015