11Other Additional Equipment - Hyundai Body Builder 2015 Manual

INTRODUCTION PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION
4.12.11 Other additional equipment
Other groups such as winches, snow plough device, hydraulic jack, etc., must be ap-
proved and will be installed following the instructions and recommendations of the
respective manufacturers.
The permissible axle weights and the permissible Centre of Gravity positions must
be respected at all times.
A winch at the rear of the frame must be mounted on a suitably dimensioned sup-
porting structure.
- A winch must not be installed on the front of the vehicle.
- The newly installed equipment must not affect the operation of other vehicle
- The Body Builder should facilitate the manual operation of the new equipment
For the installation of groups in special vehicles such as fire engines, refuse collec-
tion vehicles, etc., special settings are needed for the chassis.
- Authorisation from the competent department is required before installing
- For more information about HMC reference departments:
- More information about certificates of conformity can be found in:
138
POWER TAKE-OFF
NOTICE
The freedom of movement of vehicle components must be guaranteed in all
driving situations.
groups or equipment.
installed on delivery of the vehicle.
NOTICE
special equipment.
See General Book, chapter 2.4 "Contact possibilities".
General Book, chapter 2.6 "Verification and certification of superstruc-
tures ".
Body Builder Manual Part II, Specific Book LCV
MAINTENANCE AND DAMAGE PREVENTION
ELECTRIC AND ELECTRONIC SYSTEMS
WORK ON BASIC VEHICLE
APPENDIX
V1.0, February 2015