Undercover - Hyundai Body Builder 2015 Manual

INTRODUCTION PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION
When installing wind deflectors on the cab, the following points must be taken into
account:
-
-
-
-

4.12.6 Undercover

To prevent corrosion at the lower front area of the engine, it is possible to install
an undercover under the engine.
1
Fig. 4-91
V1.0, February 2015
POWER TAKE-OFF
Attention should be paid, to ensure that the wind deflector mounts do not dam-
age the paint or the bodyshell in any state of use.
The device must be properly secured, so that no vibrations or noise occur.
No holes must be made in the roof cab to install the wind deflector. It must be
installed with strong adhesives, or another method.
Both the weight of the element and the pressure exerted on it by the air when
the vehicle is in motion should be taken into account.
See chapter 2.3.3 "Weight distribution".
Engine
LCV_SPBGC412_009 Engine undercover
Body Builder Manual Part II, Specific Book LCV
MAINTENANCE AND DAMAGE PREVENTION
ELECTRIC AND ELECTRONIC SYSTEMS
2 Undercover
WORK ON BASIC VEHICLE
APPENDIX
131