Hyundai Body Builder 2015 Manual page 193

INTRODUCTION PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION
The use of flexible connections, type F_2, is recommended in the additional con-
soles, as well as in the first console installed from factory.
The other consoles along the entire length of the chassis frame can be type F_1.
F_1, F_2
Fig. 5-145 SPBGC54_013
Special points to be considered
Attention must be paid to the asymmetric installation of the aerial platform. The
maximum load difference between the wheels on the same axle (unilateral axle load)
must not be exceeded.
Stability must be ensured by support feet, which are laterally extended. The use of
hydraulic feet is recommended. The support feet protruding beyond the vehicle
must be properly marked with reflective paint, reflectors, or any other signalling
method approved.
V1.0, February 2015
POWER TAKE-OFF
See chapter 5.3 "Subframe attachment".
Flexible connection type F_1, F_2
See Chapter 2.3.3 "Weight distribution".
Body Builder Manual Part II, Specific Book LCV
MAINTENANCE AND DAMAGE PREVENTION
ELECTRIC AND ELECTRONIC SYSTEMS
see chapter 5.3.2 "Flexible connection"
WORK ON BASIC VEHICLE
APPENDIX
193