Table of Contents
Advertisement
INTRODUCTION
PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION
Shortening the overhang (U
If it is necessary to reduce the rear overhang of the vehicle, the last closing cross-
member or end crossbar should not be removed under any circumstances. It must
be relocated in the new position by attaching it on the chassis frame in the same
way as it was installed in the original position.
At most, the end crossbar can be moved forward until it is at a distance of at least
350 mm (Umin) to the crossbar supporting the rear anchor point of the suspensions.
Otherwise, there would not be enough space for the installation of the coupling de-
vice. This will also prevent the new setting from affecting the free functioning of
suspensions and stabiliser bars.
Table 1-44 LCV_SPBGC42_003 Minimum overhang (U
CAUTION
The crossbar that supports the rear anchor point of the suspensions must not be
moved under any circumstances. This could cause the failure of various vehicle
systems.
62
POWER TAKE-OFF
)
min
≥ 350 mm)
min
Body Builder Manual Part II, Specific Book LCV
MAINTENANCE AND DAMAGE PREVENTION
ELECTRIC AND ELECTRONIC SYSTEMS
WORK ON BASIC VEHICLE
APPENDIX
V1.0, February 2015
Advertisement
Table of Contents
