Particular Points To Be Considered - Hyundai Body Builder 2015 Manual

INTRODUCTION PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION
5.3.6
To properly make the connection between the chassis and the body, the following
guidelines must be taken into account:
-
-
-
-
Fig. 5-117 SPBGC53_008 Shackle connection
The minimum distance between the cab and the body must be higher than 50 mm.
Fig. 5-118 SPBGC53_008 Minimum distance between cab and body - A > 50 mm
V1.0, February 2015
POWER TAKE-OFF

Particular points to be considered

Be careful that the connections are not an obstacle for the movable elements
installed in the chassis. In addition, the components of the vehicle should be
easily accessible for maintenance and repairs.
Avoid twisting the chassis frame when tightening the screws.
The nuts and bolts of the connections must be re-checked and tightened peri-
odically, with the suitable torque.
HMC recommends not using shackles to attach the chassis frame and subframe.
These can generate large bending forces on the beam flanges of the chassis
frame. These carry a high risk of wear and corrosion damage to the beams.
This damage can eventually cause cracks due to fatigue, and these can cause
failure of the structure.
NOTICE
Body Builder Manual Part II, Specific Book LCV
MAINTENANCE AND DAMAGE PREVENTION
ELECTRIC AND ELECTRONIC SYSTEMS
WORK ON BASIC VEHICLE
APPENDIX
161