Wheelbase Modification - Hyundai Body Builder 2015 Manual

INTRODUCTION PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION
Rear underride guard
The rear underride guard of the new rear frame overhang should be mounted iden-
tically to the one in the vehicle supplied from the factory.
To obtain more information about rear underride guard.
Alteration of the electrical installation
If the rear frame overhang is extended, the electrical wires from rear lights could
be too short. If there is not enough excess cable, splicing is not allowed, and the use
of new cables of the correct length should be considered.
The taillights of the vehicle should also be relocated, to ensure that they can be
seen properly.
Centre of Gravity
The maximum values of the centre of gravity must be respected. Its position should
always be ahead of the rear axle of the vehicle.
For the panel van vehicles, modification of the overhang is only allowed in special
cases. It is necessary to consult HMC before performing any modification.
To obtain more information,
ities".
4.2.6
HMC offers vehicles with different wheelbases, trying to adapt them to the maxi-
mum possible uses.
Any modification of the wheelbase of the vehicle is prohibited.
Modification of the wheelbase of the vehicle is not permitted. HMC shall not be
liable for any resulting problems.
V1.0, February 2015
POWER TAKE-OFF
NOTICE
See chapter 4.12.2 "Underride guards".
See Chapter 7 "ELECTRIC AND ELECTRONIC SYSTEMS".
See chapter 2.3.4 "Centre of Gravity (CoG)".
NOTICE

Wheelbase modification

See chapter 2.2 "Range of vehicles supplied by HYUNDAI".
NOTICE
Body Builder Manual Part II, Specific Book LCV
MAINTENANCE AND DAMAGE PREVENTION
ELECTRIC AND ELECTRONIC SYSTEMS
see General Book, chapter 2.4 "Contact possibil-
WORK ON BASIC VEHICLE
APPENDIX
67