Hyundai Body Builder 2015 Manual page 246

INTRODUCTION PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION
ADJUSTMENT OF FRONT FOG LIGHT (BASED ON 10 m SCREEN)
1 Ground
2 Cut-off line
3 Horizontal line of fog lamp bulb centre
4 W3 (front fog)
1. Turn the front fog lamp on with the driver (75 kg) aboard.
2. The cut-off line should be projected in the permissible range
(shaded region).
Table 1-179 SPBTC75_002 Adjustment of front fog light (based on 10 m screen)
NOTICE
The headlamps, which are projection type lamps, must be adjusted with a deck
width that exceeds 2236 mm.
See chapter 2.3.2 "Main vehicle dimensions"- Table LCV_SPBTC23_005.
Rear lamps
These lamps are used to indicate the presence and width of the vehicle when it is
viewed from behind. The rear lamps fitted as standard on its support are approved
for either horizontal or vertical assembly, depending on the needs of the body.
When the moving parts of the body (rear tail lifts, platforms for carrying vehicles)
are being operated, situations should be avoided where more than 50 % of the rear
lamps are hidden. If this is not possible, the rear lamps must be relocated.
The new situation of the rear lamps - in terms of size and visibility - must always
comply with the provisions of the regulations in force.
246
MAINTENANCE AND DAMAGE PREVENTION
POWER TAKE-OFF
5 Upper limit, 180 mm
6 Car axis
7 Vertical line of right fog lamp bulb centre
8 Vertical line of left fog lamp bulb centre
DESCRIPTION
Body Builder Manual Part II, Specific Book LCV
ELECTRIC AND ELECTRONIC SYSTEMS
WORK ON BASIC VEHICLE
APPENDIX
V1.0, February 2015