Table of Contents
Advertisement
INTRODUCTION
PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION
The following should be taken into account:
-
Do not modify or manipulate the control units in any way.
-
Do not disconnect the connectors of the control units.
-
Do not use a quick battery charger for emergency starts, as this could damage
the electronics system, and especially the control units.
-
Do not subject the control units to sources of high heat (> 80 ° C). Do not install
heat-producing items or equipment in the vicinity of a control unit.
-
If for any reason, a control unit has to be disassembled, an official Hyundai
service centre should be contacted to disassemble and subsequently re-
assemble the control unit correctly.
-
A control unit must not be installed in a different place to the original place, nor
must any fixation system other than the original be used.
-
If a control unit has received a blow or fallen, it must be checked to see that it
works properly.
254
MAINTENANCE AND DAMAGE PREVENTION
POWER TAKE-OFF
Body Builder Manual Part II, Specific Book LCV
ELECTRIC AND ELECTRONIC SYSTEMS
WORK ON BASIC VEHICLE
APPENDIX
V1.0, February 2015
Advertisement
Table of Contents
