Table of Contents
Advertisement
INTRODUCTION
PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION
4.2.5
Sometimes it is necessary to extend or shorten the rear frame overhang; in this
case, the instructions below should be followed carefully.
Materials
The materials used in overhang modification work must match the materials and di-
mensions of the original chassis.
To obtain more information about chassis frame material:
Weight distribution
Modifying the frame overhang will result in a displacement of the vehicle's centre
of gravity. As result, a redistribution of the axle loads will occur. Therefore, before
starting modification work, the weight distribution on the axles will have to be re-
calculated, to ensure that it is within the allowed limits. The minimum load on the
front axle, that ensures steerability, will also need to be checked.
The weight of special equipment should also be considered.
V1.0, February 2015
POWER TAKE-OFF
Overhang modification
NOTICE
See Chapter 4.2.2 "Materials".
See Chapter 4.2.3 "Main sections".
See Chapter 2.3.3 "Weight distribution".
NOTICE
Body Builder Manual Part II, Specific Book LCV
MAINTENANCE AND DAMAGE PREVENTION
ELECTRIC AND ELECTRONIC SYSTEMS
WORK ON BASIC VEHICLE
APPENDIX
61
Advertisement
Table of Contents
