Table of Contents
Advertisement
INTRODUCTION
PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION
If the vehicle is equipped with the ISG (Idle stop and go) and AMS (Alternator Man-
agement System) functions, there is a battery sensor instead of the normal ground
cable. Care must be taken not to damage this sensor when handling the main bat-
tery.
There are two holes in the battery for venting the H2 gas. Because the main battery
is located in the interior, this gas should be passed to the outside of the vehicle. To
do this, stop up the vent hole located near the (+) pole and connect the hose to the
vent hole located near the (-) pole. The gas from the battery is delivered to the out-
side by means of this system.
1
2
Fig. 7-172 SPBGC74_003 Main battery connections
V1.0, February 2015
POWER TAKE-OFF
Battery sensor
Earth bolt (2EA)
Front of Vehicle
Body Builder Manual Part II, Specific Book LCV
MAINTENANCE AND DAMAGE PREVENTION
ELECTRIC AND ELECTRONIC SYSTEMS
3
Vent hose
4
Main battery
WORK ON BASIC VEHICLE
APPENDIX
235
Advertisement
Table of Contents
