Cab - Hyundai Body Builder 2015 Manual

INTRODUCTION PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION
-
-
-
-
4.3.2
Interventions in the cab are very delicate, because they can affect the strength and
stiffness of the structure and also the vehicle safety systems. For this reason, all
the changes made in the cab must have the authorisation of HMC and a certificate
of conformity.
To obtain more detailed information about authorisations and certificates of con-
formity.
tures".
The guidelines in this manual must likewise be followed:
-
None of the vehicle's security systems must be affected by the modifications car-
ried out in the cab. If any system fails to work properly, an accident involving the
vehicle could cause very serious health consequences for the occupants. It is the
responsibility of the Body Builder to ensure that safety systems are working
properly prior to delivery of the vehicle.
-
-
V1.0, February 2015
POWER TAKE-OFF
At all times, regulations for drilling and welding work must be complied with, as
must the recommendations provided in this manual.
See chapter 4.1 "Prevention and recommendations".
The formation of rust on the vehicle should be prevented.
See chapter 4.1.5 "Corrosion protection".
Care must be taken to ensure that the weight distribution is right after
modification work.
See chapter 2.3.3 "Weight distribution".
A perfect seal against water filtrations, dust or smoke must always be ensured.
Likewise, care must be taken to ensure that the noise level is within the permit-
ted limits.
See chapter 2.3.9 "Noise insulation".

Cab

NOTICE
See General Book, chapter 2.6 "Verification and certification of superstruc-
Special attention should be paid not to alter any vehicle safety systems such as
airbags, security bells, sensors, etc.
WARNING
The standards relating to interior fittings for vehicles should be taken into
account. In this way, edges or sharp corners must be avoided, and a check must
be carried out on outgoing edges inside the cab, with a view to possible impacts
with occupants' heads.
Control devices may be installed in the vehicle cab. They must be within easy
reach of the driver and must not impair vision or access to other serial devices
installed in the cab.
Body Builder Manual Part II, Specific Book LCV
MAINTENANCE AND DAMAGE PREVENTION
ELECTRIC AND ELECTRONIC SYSTEMS
WORK ON BASIC VEHICLE
APPENDIX
69