Hyundai Body Builder 2015 Manual page 205

IINTRODUCTION PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION
To activate the PTO system
-
-
-
-
To deactivate the PTO system
-
-
-
The main purpose of the activation control system is to connect the PTO in a safe
way. Before activating the PTO, the control unit will check if the proper conditions
are met, such as is there sufficient pressure in the pneumatic system, is the vehicle
completely stopped, etc.
Peak load at start-up
The maximum torque of the PTO is referenced to uniform loads.
This value must not be exceeded, as this would lead to damage in the system.
Lubrication and temperature control of the PTO
The conditions of lubrication are very important, since the PTO is a device in which
high temperatures are reached, which has the potential to cause damage in the sys-
tem. Therefore, care must be taken to ensure that the PTO is properly lubricated.
The lubrication of the power take off depends largely on the inclination of the ve-
hicle. Care should be taken to avoid activating the PTO when the vehicle is on a slope
with a high angle of inclination. If necessary, use only for short periods of time un-
der these circumstances.
V1.0, February 2015
POWER TAKE-OFF
Stop the vehicle and apply the parking brake.
Depress the clutch pedal to disconnect the power.
Wait for 2 to 3 seconds.
Press ON the PTO switch.
Then, slowly take your foot off the clutch pedal.
Make sure that the PTO indicator illuminates on the cluster.
Depress the clutch pedal.
Press OFF the PTO. switch.
Then, slowly take your foot off the clutch pedal.
Make sure that the PTO indicator goes OFF on the cluster.
Body Builder Manual Part II, Specific Book LCV
MAINTENANCE AND DAMAGE PREVENTION
ELECTRIC AND ELECTRONIC SYSTEMS
WORK ON BASIC VEHICLE
APPENDIX
205