Windows - Hyundai Body Builder 2015 Manual

INTRODUCTION PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION
4.3.5

Windows

When a new window is incorporated in the vehicle, it must be surrounded by a rigid
perimeter frame. This frame must be connected to other structural elements with
rigid connections. The windows must be accommodated between two pillars of the
structure, they should not be cut.
At all events, after the modification has been carried out, similar strength and stiff-
ness to the original vehicle must be ensured.
Authorisation from HMC is needed before performing the work.
NOTICE
- To obtain more detailed information about authorisations and certificates of
conformity.
See General Book, chapter 2.6 "Verification and certification of super-
structures".
Table 1-52 LCV_SPBGC43_002 Position for subsequent installed windows
If the Body Builder wants to modify the existing window panes, exchanging them
for others with different characteristics, care should be taken to ensure that they
comply with the standard in force.
If the Body Builder wants to change the windows panes in the rear doors of the ve-
hicle, they must have the same curvature as originals installed in the factory, so the
wiper system can work properly.
The new windows should be completely impervious to dust, smoke or other particles,
as well as meeting the minimum requirements for noise insulation.
76
MAINTENANCE AND DAMAGE PREVENTION
POWER TAKE-OFF
Body Builder Manual Part II, Specific Book LCV
ELECTRIC AND ELECTRONIC SYSTEMS
WORK ON BASIC VEHICLE
APPENDIX
V1.0, February 2015