Table of Contents
Advertisement
INTRODUCTION
PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION
If such changes are made, a number of requirements must be met:
-
1
Table 1-49 LCV_SPBGC43_007 Cab - cutting areas
-
Keep in mind the requirements and recommendations when performing drilling
and welding work on the vehicle. It must also be protected against corrosion.
To obtain more detailed information about modification inside the cab.
V1.0, February 2015
POWER TAKE-OFF
Cuts must only be made in the designated areas, as shown in figure.
Cutting area
The original structure that has been removed should be replaced by a new
structure, such as a perimeter frame. This should ensure strength and rigidity
equal to that of the original cab. The performance of the safety belts should
not be affected by the deformation of the structure.
NOTICE
See chapter 4.1 "Prevention and recommendations".
See chapter 4.5 "Interior modifications".
Body Builder Manual Part II, Specific Book LCV
MAINTENANCE AND DAMAGE PREVENTION
ELECTRIC AND ELECTRONIC SYSTEMS
*
all dimension in mm
WORK ON BASIC VEHICLE
APPENDIX
71
Advertisement
Table of Contents
