Hyundai Body Builder 2015 Manual page 191

INTRODUCTION PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION
The subframe also provides the necessary crane height to ensure proper
clearance, so that the operation of the other components of the vehicle will not be
affected.
For more information about subframe design
The platform must be attached to the chassis frame at the midpoint between the
first two consoles installed from factory in the vehicle. In this axis, a cross-member
must be mounted to protect the subframe against torsion forces which occur when
operating the platform. This cross-member is also used to protect against the forc-
es transmitted by the support feet. The installation of another cross-member is rec-
ommended in the rear of the vehicle if a support foot is installed in the overhang.
1
2
Fig. 5-143 LCV_SPBGC54_011
V1.0, February 2015
POWER TAKE-OFF
NOTICE
See Chapter 5.2 "Subframe features and design".
Cross member preventing torsion
Subframe
Body Builder Manual Part II, Specific Book LCV
MAINTENANCE AND DAMAGE PREVENTION
ELECTRIC AND ELECTRONIC SYSTEMS
3 Support feet
WORK ON BASIC VEHICLE
APPENDIX
191