Equipment Installed On Roof - Hyundai Body Builder 2015 Manual

Table of Contents

Advertisement

INTRODUCTION
PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION

4.12.8 Equipment installed on roof

When installing equipment on the roof, e.g. roof racks, chillers, wind deflectors, etc.,
some considerations must be observed:
-
-
When installing roof racks on the roof of a van, the Body Builder must move the
antenna to another location. The remaining hole should be properly covered, to
ensure it is waterproof.
-
-
-
-
In vehicles which are for the transport of people and have an emergency exit
through the roof, the mounting of any kind of equipment on the roof is forbidden,
if this would cover all or part of the emergency exit hole. This would prevent the
occupants from escaping or being rescued after an accident, and delay the medi-
cal care of any injured persons.
136
POWER TAKE-OFF
The variation of the centre of gravity of the vehicle should be considered.
Check that it is within the permissible limits. It is recommended that a stabiliser
bar should be used on the front axle if necessary.
See chapter 2.3.4 "Centre of Gravity (CoG)".
Check that the axle load is within the permissible limits. It is also necessary be
verify that the minimum load on the front axle is met.
See chapter 2.3.3 "Weight distribution".
NOTICE
See chapter 7.6 "Communication Systems".
The maximum permissible load on the roof must not be exceeded. Installation
should be carried out in such a way as to ensure as well as possible that loads
are evenly distributed over the entire roof surface. The use support legs
installed at regular distances is recommended.
In vehicles in which it is necessary to install an escape hatch, such as a passen-
ger vans, the installation of any equipment that might prevent entry or exit
through this opening, if it needs to be used as an emergency exit, is forbidden.
Considerations of the ECE Regulation No R 107 must be respected.
The specific manufacturer's instructions should always be borne in mind.
The installation will not produce vibration or noise.
WARNING
Body Builder Manual Part II, Specific Book LCV
MAINTENANCE AND DAMAGE PREVENTION
ELECTRIC AND ELECTRONIC SYSTEMS
WORK ON BASIC VEHICLE
APPENDIX
See chapter 4.3.3 "Roof".
V1.0, February 2015

Advertisement

Table of Contents
loading

Table of Contents