Hyundai Body Builder 2015 Manual page 20

INTRODUCTION PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION
In addition to this identification plate, the vehicles incorporate a certification label
plate on which relevant technical specifications of the vehicle are written, such as
the model, the maximum authorised weight, which is attached on the driver´s (or
front passenger´s) side centre pillar. It also normally gives the vehicle identification
number (VIN).
Fig. 2-17 Technical characteristics plate
1 Driver seat
2 B-pillar
NOTICE
None of these plates should be modified or installed elsewhere.
Special equipment
In addition to the standard equipment, vehicles supplied by HMC may include option-
al equipment (always on prior request), with the intention of adapting the vehicle as
well as possible to the final task.
The fact that the installation of this special equipment will increase the weight of
the vehicle should be taken into account. For this reason, it is recommended that
the vehicle should be weighed before starting construction work, in order to know
the actual weight.
NOTICE
To obtain more information about special equipment supplied, contact HMC.
See General Book, chapter 2.4 "Contact Possibilities".
20
MAINTENANCE AND DAMAGE PREVENTION
POWER TAKE-OFF
3 Technical characteristics plate
Body Builder Manual Part II, Specific Book LCV
ELECTRIC AND ELECTRONIC SYSTEMS
WORK ON BASIC VEHICLE
APPENDIX
V1.0, February 2015