Tractor For Semi-Trailers - Hyundai Body Builder 2015 Manual

INTRODUCTION PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION
Subframe features
Type of connections:
Special points to be considered
If the bodyshell of the vehicle has to be modified to install the cooling unit, the
guidelines in this manual must be followed.
Special attention must be paid to noise transmission due to the groups installed in
the vehicle, and the level kept within the permissible values.
The guidelines and recommendations for Power Take Offs (PTOs) must also be fol-
lowed.
The instructions in this manual for the installation of the electrical equipment for
cooling the vehicle must be followed.
5.4.7
General considerations
This type of vehicle is made up of two parts, the first is the tractor unit or the drive
unit, and the second is the semi-trailer, which is pulled and carries the cargo. The
connection between the two elements mentioned above is performed by a device
known as the fifth wheel.
Fig. 5-128 SPBGC53_023 Semi-trailer tractor
These vehicles must be specifically developed to withstand the high load conditions,
braking forces and road holding behaviour related to pulling a semi-trailer.
174
POWER TAKE-OFF
See chapter 5.4.3 "Van bodies".
See chapter 5.4.3 "Van bodies".
See chapter 4.3 "Bodyshell modifications".
See chapter 4.5.2 "Noise insulation".
See chapter 6 "POWER TAKE-OFF".
See chapter 7 "ELECTRIC AND ELECTRONIC SYSTEMS".

Tractor for semi-trailers

Body Builder Manual Part II, Specific Book LCV
MAINTENANCE AND DAMAGE PREVENTION
ELECTRIC AND ELECTRONIC SYSTEMS
WORK ON BASIC VEHICLE
APPENDIX
V1.0, February 2015