Hyundai Body Builder 2015 Manual page 53

INTRODUCTION PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION
There are a number of guidelines to follow:
-
-
-
-
a
Fig. 4-38
-
S
a
Fig. 4-39
V1.0, February 2015
POWER TAKE-OFF
The maximum current is 40 A per mm of electrode diameter.
Gas-shielded welding is permissible.
Only use welding wires with a thickness of between 1 and 1.2 mm.
There should be a relation between the thicknesses of the pieces to be welded.
Plate thickness, 1st sheet
LCV_SPBGC41_003
b
a
To avoid melting core damage, the specified distances to the sheet edge must
be maintained:
Slot
≥ 6 mm
LCV_SPBGC41_005 Resistance weld spots - allowable distances
Body Builder Manual Part II, Specific Book LCV
MAINTENANCE AND DAMAGE PREVENTION
ELECTRIC AND ELECTRONIC SYSTEMS
b Plate thickness, 2nd sheet
≤ 3 (a+b) ≤ 6 mm
H Hole
b ≤ 12 mm
WORK ON BASIC VEHICLE
APPENDIX
53