Hyundai Body Builder 2015 Manual page 186

INTRODUCTION PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION
The maximum distance between the last rear cross-member of the chassis frame
and the centre of gravity of the load on the tail lift must not exceed 600 mm.
Fig. 5-138 SPBGC54_009 CoG of the load on the tail lift, X ≤ 600mm
HMC recommends mounting a stabiliser bar in both the rear and front axles.
The maximum permissible lifting loads are showed in the table below:
MODEL WHEELBASE
3.5 t
5.0 t
Table 1-139 SPBTC54_001 Maximum permissible lifting loads
186
POWER TAKE-OFF
MAXIMUM LIFTING FORCE
(mm)
Panel Van
3,435 5.0
3,670 5.0
4,330 5.0
3,435 5.0
3,670 5.0
4,330 5.0
4,330 - -
Body Builder Manual Part II, Specific Book LCV
MAINTENANCE AND DAMAGE PREVENTION
ELECTRIC AND ELECTRONIC SYSTEMS
(kN)
Chassis cab
5.0
5.0
5.0
7.5
7.5
7.5
5.0
WORK ON BASIC VEHICLE
MINIMUM DIMENSION
MOUNTING FRAME MEMBER
(mm)
120 x 50 x 4
V1.0, February 2015
APPENDIX