Hyundai Body Builder 2015 Manual page 112

INTRODUCTION PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION
-
d
Fig. 4-79
-
Fig. 4-80
-
-
112
POWER TAKE-OFF
The routing of the pipe should be as regular as possible. A minimum permissible
bending radius must be respected, and narrowing avoided in the section.
pipe diameter
LCV_SPBGC41_002 Minimum permissible bending radius
The supports to fix the new pipe must be approved or supplied by HMC, and the
maximum distance between them should be 1000 mm.
LCV_SPBGC41_003 Exhaust pipe support
The exhaust pipe must be welded so that the exhaust gas cannot escape.
See chapter 4.1.4 "Welding work".
No modification of the positions of the sensors or other relevant parts of the
system is allowed.
Body Builder Manual Part II, Specific Book LCV
MAINTENANCE AND DAMAGE PREVENTION
ELECTRIC AND ELECTRONIC SYSTEMS
r 2,5 x D
min
WORK ON BASIC VEHICLE
APPENDIX
V1.0, February 2015