Wheelbase - Hyundai Body Builder 2015 Manual

INTRODUCTION PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION
The following table shows the maximum recommended height of the centre of
gravity of the pay load and upper body at full capacity:
VEHICLE MODEL
3.5 t
5.0 t
Table 1-27 SPBTC23_003 Max. height of Centre of Gravity
If special circumstances make it necessary to exceed the recommended heights, ap-
propriate measures must be taken to ensure the stability of the vehicle, such as the
installation of roll bars or the reinforcement of springs. At all events, HMC shall not
be liable for calculus or the justifications required for vehicle homologation.
NOTICE
For information on the calculation of the position of the centre of gravity
Appendix A2 "Calculation - Centre of Gravity".
2.3.5

Wheelbase

HMC offers vehicles with different wheelbases, trying to adapt them to the maxi-
mum possible uses.
See chapter 2.2 "Range of vehicles supplied by HYUNDAI".
If, among the series of vehicles offered, the wheelbase required to develop the in-
tended function is not supplied, the wheelbase may be modified by means of an
intervention on the chassis of the vehicle.
NOTICE
Wherever possible, HMC recommends using a wheelbase with the same dimen-
sions as those supplied as standard, since in this way, it is also possible to use ori-
ginal pieces, such as propeller shafts, electric cables, brake lines etc.
NOTICE
Changing the wheelbase of the vehicle affects the properties of the chassis.
Therefore changes can only be made in cases where it is strictly necessary, and
always with the written consent of HMC. Also, the rules and guidelines specified in
this manual must be followed at all times. To obtain more detailed information
about certification.
tion of superstructures".
NOTICE
The company that performs the work of modifying the wheelbase should be a
specialist company with qualified personnel.
34
POWER TAKE-OFF
MAX. COG HEIGHT (WITH VDC)
See General Book, chapter 2.6 "Verification and certifica-
Body Builder Manual Part II, Specific Book LCV
MAINTENANCE AND DAMAGE PREVENTION
ELECTRIC AND ELECTRONIC SYSTEMS
1,470 mm
-
WORK ON BASIC VEHICLE
APPENDIX
see
V1.0, February 2015