Ce Marking - Hyundai Body Builder 2015 Manual

INTRODUCTION PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION
5.1.3
The CE marking is a label under which a manufacturer declares that all applicable
regulations have been complied with.
More specifically, it indicates:
-
-
-
-
-
-
-
-
-
-
The ratios are as follows:
Fig. 5-98
V1.0, February 2015
POWER TAKE-OFF

CE marking

That the product complies with all the requirements of the directives that apply.
That the assessment procedures required for conformity have been carried out.
The CE marking may only be affixed by the manufacturer or his authorised
representative (within the EC), always before the product is marketed.
The manufacturer is also responsible for the certification procedures.
The CE marking must have the following characteristics:
The manufacturer must add it conspicuously, legibly and indelibly to the product
to be supplied, according to the format provided by law.
If, due to the appearance and manufacturing method of a product, the CE
marking cannot be added to it, then in this case the marking should be on the
packaging and the documents accompanying the product.
If the Directive requires the involvement of a Notified Body in the process of
conformity assessment, its identification number must be placed behind the CE
marking. This is done under the responsibility of the Notified Body.
The ratios must be maintained, and the minimum vertical dimension should be
5 mm.
The use of signs which might be confused with the "CE" marking, both in mean-
ing and form, is forbidden. A product may bear other marks or stamps, provided
they are not confused with the "CE" marking, and do not reduce its the legibility
and visibility.
SPBGC51_001 Dimensions and ratios of the CE marking
Body Builder Manual Part II, Specific Book LCV
MAINTENANCE AND DAMAGE PREVENTION
ELECTRIC AND ELECTRONIC SYSTEMS
WORK ON BASIC VEHICLE
APPENDIX
145