Hyundai Body Builder 2015 Manual page 65

INTRODUCTION PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION
Use of additional crossbars:
When extending the rear frame overhang, it must be checked that the distance be-
tween crossbars is not more than 400 mm. Should it not be within this range, the
possibility of installing an additional crossbar should be considered, to ensure suf-
ficient torsional stability.
Additional crossbars should have the same characteristics as originals and must
perform the same function.
A
Table 1-47 LCV_SPBGC42_006 Additional crossbar
Use of end crossbar
The end crossbar must always be installed, even if there is no intention to tow a
trailer.
If a tow bar is mounted, then the necessary reinforcements should be added. In this
case, a distance of at least 350 mm between the end crossbar and the nearest
crossbar must be considered, to ensure that the trailer coupling can be assembled
and disassembled without problems.
V1.0, February 2015
POWER TAKE-OFF
X
≤ 400 mm
Body Builder Manual Part II, Specific Book LCV
MAINTENANCE AND DAMAGE PREVENTION
ELECTRIC AND ELECTRONIC SYSTEMS
B X ≥
400 mm
1 Additional crossbar
WORK ON BASIC VEHICLE
APPENDIX
65