Hyundai Body Builder 2015 Manual page 198

INTRODUCTION PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION
Transmission of forces between the cab and body should be ensured. This can be
achieved, for example, by the options below:
-
-
1
2
3
Table 1-150 SPBTC54_002
The following should also be taken into account:
-
-
-
-
198
POWER TAKE-OFF
Option A: The fixation between the B-pillar and the upper body can be effected
by means of a vertical sheet (tightness ≥ 2 mm), which must be bonded across
its entire length.
Option B: The fixation between the B-pillar and the upper body can be effected
by means of angle sections, by riveting them.
FIXATION BETWEEN B-PILLAR AND UPPER BODY
B-pillar
Vertical plate
Bonding flange
A perfect seal must be ensured between cab and body.
Regulations regarding noise must be complied with.
See chapter 2.3.9 "Noise insulation".
Parts of the cab involved in the modification must be protected from corrosion.
See chapter 4.1.5 "Corrosion protection".
The standards and recommendations for welding, drilling and screwing must be
complied with.
See chapter 4.1 "Prevention and recommendations".
Body Builder Manual Part II, Specific Book LCV
MAINTENANCE AND DAMAGE PREVENTION
ELECTRIC AND ELECTRONIC SYSTEMS
4 Body side wall
5 Rivets
6 Angle section
WORK ON BASIC VEHICLE
APPENDIX
V1.0, February 2015