Table of Contents
Advertisement
INTRODUCTION
PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION
Preventions
In any modification or maintenance work carried out on the vehicle's electrical sys-
tem, a number of precautions must be observed:
-
Before performing any work on the electrical system, the negative terminal of
the battery should be disconnected.
-
When unplugging a connector, it must be unlocked and released. Never pull the
wire to release the connector.
-
When connecting a new battery, care should be taken to ensure that polarity is
not inverted, and that the terminals are firmly connected.
-
Use fuses with the specified capacity for the specific function, never use a
higher capacity fuse.
WARNING
Interventions that do not meet with the instructions supplied by HMC or which
have been made by non-qualified workers can cause serious damage to the basic
electrical system, and this is not covered by the warranty contract.
NOTICE
The regulations on safety and the prevention of accidents must be complied with.
Electrical work must always be performed by qualified personnel.
7.2.5
Wiring diagrams
The wiring diagrams for the vehicle are available for Body Builders on request. HMC
must be contacted.
In cases where modifications or new installations in the vehicle are important, the
Body Builder will develop its own wiring diagrams. These must be reviewed by HMC,
to see if everything is suitable for approval. They will later beadded to the official
documentation for the vehicle.
220
POWER TAKE-OFF
See General Book, chapter 2.4 "Contact possibilities".
Body Builder Manual Part II, Specific Book LCV
MAINTENANCE AND DAMAGE PREVENTION
ELECTRIC AND ELECTRONIC SYSTEMS
WORK ON BASIC VEHICLE
APPENDIX
V1.0, February 2015
Advertisement
Table of Contents
