Hyundai Body Builder 2015 Manual page 31

INTRODUCTION PRELIMINAR STUDIES AND CONSIDERATIONS
MOUNTING AND CONSTRUCTION
Positioning the centre of gravity on the X-axis of the vehicle
The CoG must be always positioned as close as possible to the rear axle of the ve-
hicle and always ahead of (D), in the area defined by the wheelbase (WB).
See Chapter 2.3.5 "Wheelbase".
In this way we ensure not only the stability of the vehicle in unloading conditions or
during the tilting process, but also the requisite minimum load on the front axle that
ensures proper steerability.
See Chapter 2.3.3 "Weight distribution" - Minimum load on the front axle.
D Distance from CoG to the rear axle
Fig. 2-24 Centre of gravity on the X-axis
CAUTION
Particular attention should be paid when installating equipment at the rear, such
as load cranes, tilt platforms, etc. They produce high punctual loads, and
therefore a displacement of the CoG.
In this case, decreasing the total length of the vehicle should be considered, in
order to keep the CoG in the permissible area.
V1.0, February 2015
MAINTENANCE AND DAMAGE PREVENTION
POWER TAKE-OFF
WB Wheelbase
Body Builder Manual Part II, Specific Book LCV
ELECTRIC AND ELECTRONIC SYSTEMS
WORK ON BASIC VEHICLE
APPENDIX
31