Interface - Brocade Communications Systems RFS4000 Cli Reference Manual

5
Global Configuration commands

interface

Global Configuration commands
Configures a selected interface
This command is used to enter the interface configuration mode for the specified physical
Controller Virtual Interface (SVI) interface. If the VLANx (SVI) interface does not exist, it is
automatically created.
Supported in the following platforms:
•
•
•
NOTE
The interfaces mentioned below are supported in the following platforms:
- ge <index> – Mobility RFS7000 Controller supports 4 GEs, Mobility RFS6000 Controller supports
8 GEs and Mobility RFS4000 Controller supports 5 GEs
- sa <index> – Mobility RFS7000 Controller supports 4 SAs and Mobility RFS4000 Controller
supports 6 SAs
- me1 – Supported with Mobility RFS7000 Controller, Mobility RFS4000 Controller and Mobility
RFS6000 Controller
- up1 – Supported with Mobility RFS6000 Controller and Mobility RFS4000 Controller.
NOTE
The interface mode leads to the
on page
RFController(config-if)
Syntax (Mobility RFS7000 Controller)
Syntax (Mobility RFS6000 Controller)
Syntax(RFS4000)
250
Mobility RFS4000 Controller
Mobility RFS6000 Controller
Mobility RFS7000 Controller
403. The prompt changes from
interface [<interface-name>|ge <1-4>|me1|sa <1-4>|vlan <1-4094>]
interface [<interface-name>|ge <1-8>|me1|up1|vlan <1-4094>]
interface [<interface-name>|ge <1-5>|me1|up1|sa <1-6>|vlan <1-4094>|wwan]
instance. For more information, see
config-if
RFController(config) #
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
Interface Instance
to
53-1001931-01