Brocade Communications Systems RFS4000 Cli Reference Manual page 716

21
RTLS config commands
no
RTLS config commands
Negates a RTLS command or set its defaults
Supported in the following platforms:
•
•
•
Syntax
Parameters
aeroscout [enable|
multi-cast-listen|addr]
ekahau
[enable|engine|multicast]
reference-tag [rfid]
service [filter <1-100>
{length|
memory-bank|offset
}|inventory
{<1-100>|default]
site
zone<1-48>
ap [MAC Address
<coordinates>]
controller [coordinates
|geo-coordinates]
714
Mobility RFS4000 Controller
Mobility RFS6000 Controller
Mobility RFS7000 Controller
no [aeroscout|ekahau|reference-tag|service|site|
controller|ap|zone]
Negates aeroscout configuration
•
•
Negates ekahau configuration
•
•
•
Negates reference-tag configuration
•
Negates service configuration for:
•
•
Negates site configuration
Negates zone configuration
•
•
enable – Disable SOLE adapter
multicast-listen-addr– Configure multicast listening address
enable – Disable aeroscout external engine
engine –reset external location engine parameters
multicast-listen-addr– Configure multicast listening address
rfid– Negates configuring rfid tag
filter <1-100> {length|memory-bank|offset} – Negates RFID
tag filter configuration for the selected index
•
length – Length of tag filter
•
memory-bank – Tag memory bank
•
offset – Offset into the tag memory bank
inventory [<1-100>|default] – Negates tag inventory for the
selected index or the default index
•
filter – Configures tag filter for inventory
•
start – Starts tag inventory
•
start-trigger – Removes start trigger for tag inventory
•
stop-trigger – Removes stop trigger for tag inventory
•
zone – Configures logical reader
AA-BB-CC-DD-EE-FF – Disables access point MAC IP address
•
coordinates – Negates AP location configuration
Negates controller configuration parameters
•
coordinates – Negates controller coordinates
configuration within the site
•
geo-coordinates – Negates controller geo coordinates
configuration
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01