Brocade Communications Systems RFS4000 Cli Reference Manual page 654

20
Wireless configuration commands
group-id <1-256>
location-led
[start-flashing|
stop-flashing]
location-message
<message>
mac <MAC>
max-wireless-clients
<1-256>
mesh-associations <1-3>
client-power <0-20>
nas-id <ID>
nas-port-id <ID>
on-channel-scan
radio-number <0-2>
radar-test-mode enable
reset
reset-ap
rf-mode [a|an|b|bg|bgn|
custom|g|n]
rss enable
rts-threshold <0-2347>
run-acs
self-heal-offset <0-30>
652
Specifies the radio groups to balance user load.
•
Mobility RFS7000 Controller
For
group identifier used for an access-point, 0 disables the
grouping.
•
For Mobility RFS6000 Controller, <0-64> – Radio group
identifier used for an access-point, 0 disables the grouping.
Changes the mode of operation of the LEDs on an AP.
•
start-flashing – Requests parent-ap of specified radio to
begin flashing its LEDs to help locate it.
•
stop-flashing – Requests parent-ap of specified radio to
revert its LEDs to normal mode of operation.
Specifies a message sent to all wireless clients that associate with
these radios. This message <message> should not exceed 80
characters.
Changes the parent (access-point) MAC address of the radio.
Maximum number of wireless clients allowed to associate.
Displays Client bridge mesh associations
•
<1-3> – Displays number of mesh assocations
Power adjustment level for wireless clients associated with this
access-point. clients that support this element will reduce their
transmit power by the specified value.
•
<0-20> – Power adjustment level in dBm.
Configures a NAS ID for this radio. <ID> can be up to 256
characters long.
Configures a NAS port id for this radio. <ID> can be up to 256
characters long.
Enables rogue scanning on this radio.
Enter the radio number only if there are two similar radios on the
AP. Enter 0 (zero) or omit when there is no ambiguity.
Enables the radar test mode.
Resets a radio (this will only reset the specified radio, not the
complete access point).
Resets the parent AP (this will reset all radios on that access
point).
Selects the radio speed based on the radio mode selected.
Remote Site Survivability (RSS) enables the delivery of secure
uninterrupted wireless service in remote locations in the event of
a device failure.
Defines the RTS threshold in bytes.
Runs an auto-channel-selection on a radio. The radio should
already have been configured for ACS support.
Configures the self-healing offset (measured in dBm), for
regulatory compliance.
NOTE: The offset is based off the regulatory maximum power for
the specified channel ("show wireless regulatory" displays
the max power allowed).
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
, <0-255> – Radio
53-1001931-01