Address - Brocade Communications Systems RFS4000 Cli Reference Manual

address

DHCP Config commands
Specifies a range of addresses for the DHCP network pool
Supported in the following platforms:
•
•
•
Syntax
Parameters
range <low IP address>
<high IP address>
Usage Guidelines
Use the
server assigns IP address to DHCP clients from the address range. A high IP address is the upper
limit for providing the IP address, and a low IP address is the lower limit for providing the IP
address.
Use the
Example
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Mobility RFS4000 Controller
Mobility RFS6000 Controller
Mobility RFS7000 Controller
address range <low IP address> <high IP address>
command to specify a range of addresses for the DHCP network pool. The DHCP
address
no address range
RFController(config-dhcp)#address range 2.2.2.2 2.2.2.50
RFController(config-dhcp)#
Adds an address range for the DHCP server
•
low IP address – Defines the first IP address in the
address range
•
high IP address – Defines the last IP address in the
address range
command to remove the DHCP address range.
DHCP Config commands
17
509