Brocade Communications Systems RFS4000 Cli Reference Manual page 245

Brocade communications systems network router user manual
Hide thumbs Also See for RFS4000:
Table of Contents

Advertisement

1. Configuration required on controller 1:
2. Configuration required on controller 2:
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
a. Create an extended ACL. This is used to define the tunnel used by the traffic.
RFController(config)#access-list 150 permit ip 12.1.1.0/24 13.1.1.0/24
rule-precedence
b. Create and configure ISAKMP parameters.
RFController(config)#crypto isakmp keepalive 10
RFController(config)#crypto isakmp key ADBROCADE address 15.1.1.20
RFController(config)#crypto ipsec security-association lifetime
kilobytes 4608000
c.
Create and configure ISAKMP policy.
RFController(config)#crypto isakmp policy 199
RFController(config-crypto-isakmp)#encryption aes
RFController(config-crypto-isakmp)#hash sha
RFController(config-crypto-isakmp)#authentication pre-share
RFController(config-crypto-isakmp)#group 5
RFController(config-crypto-isakmp)#lifetime 9496
d. Create and configure an IPSec transform set.
RFController(config)#crypto ipsec transform-set TFSET ah-sha-hmac esp-aes
RFController(config-crypto-ipsec)#mode tunnel
e. Create and configure a crypto map.
RFController(config)#crypto map THIRDMAP 435 isakmp
RFController(config-crypto-map)#set peer 15.1.1.20
RFController(config-crypto-map)#match address 150
RFController(config-crypto-map)#set transformset TFSET
RFController(config-crypto-map)#set security-association lifetime seconds 3600
f.
Associate the crypto map with a VLAN interface.
RFController(config)#interface vlan1
RFController(config-if)#ip address 11.1.1.10/24
RFController(config-if)#crypto map THIRDMAP
RFController(config-if)#interface vlan2100
RFController(config-if)#ip address 12.1.1.10/24
RFController(config-if)#ip route 0.0.0.0/0 11.1.1.2
a. Create an extended ACL. This defines the tunnel used by the traffic.
RFController(config)#access-list 155permit ip 13.1.1.0/24 12.1.1.0/24
rule-precedence 1
b. Create and configure the ISAKMP parameters.
RFController(config)#crypto isakmp keepalive 10
RFController(config)#crypto isakmp key ADBROCADE address 11.1.1.10
RFController(config)#crypto ipsec security-association lifetime
kilobytes 4608000
c.
Create and configure ISAKMP policy.
Global Configuration commands
5
243

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rfs6000Rfs7000Mobility rfs6000Mobility rfs7000

Table of Contents

Save PDF