Brocade Communications Systems RFS4000 Cli Reference Manual page 242

5
Global Configuration commands
Use Case 1: Configuring Remote VPN
Let us review an example of a wireless client connected to the controller. Assume it wants access
to the corporate (trusted network) using IPSec VPN functionality.
A Brocade client is associated to a WLAN (say wlan1) attached to vlan2 on the controller. vlan2 is
on subnet 10.1.1.x and is running a DHCP server that assigns IP addresses for this subnet. The
corporate is on vlan3 of the controller, which has 192.168.0.x subnet.
The client being associated to wlan1 has an IP address of 10.1.1101x and wants to access the
192.168.0.x network securely.
240
RFController(config-trustpoint)#?
Trustpoint Config commands:
clrscr Clears the display screen
company-name Company Name(Applicable only for request)
email email
end End current mode and change to EXEC mode
exit End current mode and down to previous mode
fqdn Domain Name Configuration
help Description of the interactive help system
ip-address Internet Protocol (IP)
no Negate a command or set its defaults
password Challenge Password(Applicable only for request)
rsakeypair Rsa Keypair to associate with the trustpoint
service Service Commands
show Show running system information
subject-name Subject Name is a collection of required parameters
to configure a trustpoint.
RFController(config-trustpoint)#
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01