Configuring An Interface Port As A Layer 2 Switch Port; Configuring An Interface Port As An Access Interface; Configuring An Interface Port As A Trunk Interface - Brocade Communications Systems Converged Enhanced Ethernet 8000 Administrator's Manual

6
VLAN configuration and management

Configuring an interface port as a Layer 2 switch port

To configure the interface as a Layer 2 switch port, perform the following steps from privileged
EXEC mode.
1. Enter the configure terminal command to access global configuration mode.
2. Enter the interface command to specify the CEE interface type and slot/port number.
3. Enter the no shutdown command to enable the CEE interface.
4. Enter the switchport command to configure the interface as a Layer 2 switch port.
5. Enter the do show command to confirm the status of the CEE interface. For example
6. Enter the do show command to confirm the status of the CEE interface running configuration.

Configuring an interface port as an access interface

Each CEE interface port supports admission policies based on whether the frames are untagged or
tagged. Access mode admits only untagged and priority-tagged frames.
To configure the interface as an access interface, perform the following steps from privileged EXEC
mode.
1. Enter the configure terminal command to access global configuration mode.
2. Enter the interface command to specify the CEE interface type and slot/port number.
3. Enter the no shutdown command to enable the CEE interface.
4. Enter the switchport access command to configure the CEE interface as a Layer 2 switch port.
5. Enter the switchport mode command to set the mode of the interface to access.

Configuring an interface port as a trunk interface

Each CEE interface port supports admission policies based on whether the frames are untagged or
tagged. Trunk mode admits only VLAN-tagged frames.
To configure the interface as a trunk interface, perform the following steps from privileged EXEC
mode.
1. Enter the configure terminal command to access global configuration mode.
2. Enter the interface command to specify the CEE interface type and slot/port number.
3. Enter the no shutdown command to enable the CEE interface.
4. Enter the switchport mode trunk command to place the CEE interface into trunk mode.
50
DRAFT: BROCADE CONFIDENTIAL
switch(config)#interface tengigabitethernet 0/1
switch(conf-if-te-0/1)#do show interface tengigabitethernet 0/1
switch(conf-if-te-0/1)#do show running-config interface tengigabitethernet 0/1
switch(config)#interface tengigabitethernet 0/1
switch(conf-if-te-0/1)#switchport access vlan 20
switch(conf-if-te-0/1)#switchport mode access
switch(config)#interface tengigabitethernet 0/19
Converged Enhanced Ethernet Administrator's Guide
53-1002163-02