Convert-Ap - Brocade Communications Systems RFS4000 Cli Reference Manual

convert-ap

Wireless configuration commands
Changes the mode of operation of an AP to either sensor or standalone
Supported in the following platforms:
•
•
•
NOTE
The number of APs supported by
- Mobility RFS7000 Controller supports <1-256> APs
- Mobility RFS6000 Controller supports <1-64> APs
- Mobility RFS4000 Controller supports <1-6> APs
Parameters
<ap-index>
[default|sensor|
standalone]
Example
Converting an AP to sensor
To convert a BR300 to a sensor:
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Mobility RFS4000 Controller
Mobility RFS6000 Controller
Mobility RFS7000 Controller
convert-ap < ap-index > [default|sensor|standalone]
convert-ap <ap-index> [default|standalone]
convert-ap <ap-index> sensor {static-ip <IP/Mask>
{<gateway-IP>}}
Sets the indices of the APs to be converted.
•
•
•
NOTE: The controller will not be able to adopt this AP again until it
NOTE: The controller will not be able to adopt this AP again until
RFController(config-wireless)#convert-ap 1 default
Wireless configuration commands
command differs for each controller.
convert-ap
<ap-index> – The index of the AP to be converted. This index
can be found from the 'show wireless ap' command.
default – Does not force conversion. Lets the AP negotiate its
normal mode of operation with the controller.
sensor {static-ip <IP/Mask> {<gateway-IP>}}– Converts an
BR300 to operate as an IPS (Intrusion Prevention System)
sensor.
•
static-ip <IP/Mask> – Optional. Sensor must use
specific static IP address.
•
<IP/Mask> – Sensor IP address and network
mask.
•
<gateway-IP> – Optional. Specify gateway IP address for
sensors
is converted back to a BR300 using the
<1-256> revert-to-ap
the AP is converted back to a thin-AP using the AP's
configuration interface.
sensor
command
20
617