Brocade Communications Systems RFS4000 Cli Reference Manual page 279

Parameters
auto-revert enable
auto-revert-period
<1-1800>
critical-resource-ip
<ip_address>
dhcp-server enable
discovery-period <10-60>
dynamic-ap-load-balance
[enable|
per-ap-client-threshold|
schedule-interval|
schedule-start-time|
trigger]
enable
group-id <1-65535>
handle-stp enable
heartbeat-period <1-255>
hold-period <10-255>
interface-ip <IP>
manual-revert
member-ip <IP>
mode [primary|standby]
Example
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Enables auto-revert.
Sets the redundancy auto-revert delay interval in minutes. The
default is 5 minutes.
Sets critical resource IP address.
•
Enables the DHCP redundancy protocol.
Sets the redundancy discovery interval in seconds. The default
is 30 seconds.
Configures the different Dynamic AP Load Balance feature. The
following are the configured options:
•
•
•
•
•
Enables the redundancy protocol.
Sets the cluster ID (default cluster ID is 1).
Delays the redundancy protocol state machine exec,
considering STP.
Sets the redundancy heartbeat interval.
Sets the redundancy hold interval.
Sets the redundancy interface IP address.
Reverts standby to non-active mode.
Adds a member with the IP <IP> to this redundancy group.
Sets the mode to either primary or standby.
RFController(config)#redundancy discovery-period 20
RFController(config)#
RFController(config)#redundancy handle-stp enable
RFController(config)#
RFController(config)#redundancy heartbeat-period 20
RFController(config)#
RFController(config)#redundancy hold-period 25
RFController(config)#
RFController(config)#redundancy mode primary
RFController(config)#
Global Configuration commands
<ip_address> – IP address of the critical resource
enable – Enables Dynamic AP Load Balance
per-ap-client-threshold <1-512> – Sets the threshold
per-ap client value to trigger Dynamic AP Load Balance.
Set a value between 1 & 512
schedule-interval <1-336> – Sets the time interval days to
trigger Dynamic AP Load Balance
schedule-start-time HH:MM <1-31> <1-12>
<2008-2035> – Sets the scheduled start time for
Dynamic AP Load Balance
trigger [runtime|schedule] – Sets the trigger for running
Dynamic AP Load Balancing. Can be either runtime or
schedule
5
277