Radius-Server - Brocade Communications Systems RFS4000 Cli Reference Manual

5
Global Configuration commands

radius-server

Global Configuration commands
Enters the RADIUS server mode, the system prompt changes from the default config mode to the
RADIUS server mode
Supported in the following platforms:
•
•
•
NOTE
radius-server local
19, Radius Server
Syntax
Parameters
host <IP>
key [0 <secret>|
2 <secret>|<secret>]
local
retransmit <1-100>
timeout <1-1000>
Usage Guidelines
The RADIUS server host is used to configure RADIUS server details. These details are required for
management user authentication if AAA authentication has been defined as RADIUS
Example
274
Mobility RFS4000 Controller
Mobility RFS6000 Controller
Mobility RFS7000 Controller
mode takes you to the RADIUS server context. For more details see
Instance.
radius-server [host|key|local|retransmit|timeout]
radius-server host <IP>
radius-server key [0 <secret>|2 <secret>|<secret>]
radius-server local
radius-server retransmit <0-100>
radius-server timeout <1-1000>
Specifies a RADIUS server.
•
Sets the Encryption key shared with the RADIUS servers.
•
•
•
Configures local RADIUS server parameters. This takes you to a
new
19, Radius Server Instance
Specifies the number of retries to active server.
•
Time to wait for a RADIUS server to reply.
•
RFController(config)#radius-server local
RFController(config-radsrv)#
<IP> – Defines the IP address of RADIUS server
0 <secret> – Password is specified unencrypted
2 <secret> – Password is encrypted with
password-encryption secret
<secret> – Text of shared key, up to 127 characters
config-radius-server
for more details.
<0-100> – Number of retries for a transaction
(default is 3)
<1-1000> – Wait time (default 5 seconds)
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
Chapter
context. Refer to
Chapter
53-1001931-01