12
Interface config commands
speed
Interface config commands
Specifies the speed of a fast-ethernet (10/100) or a gigabit-ethernet port (10/100/1000)
Displays current system information running on the controller.
Supported in the following platforms:
•
•
•
Syntax
Parameters]
10
100
1000
auto
Usage Guidelines
Set the interface speed to auto to detect and use the fastest speed available. Speed detection is
based on connected network hardware.
Example
428
Mobility RFS4000 Controller
Mobility RFS6000 Controller
Mobility RFS7000 Controller
speed [10|100|1000|auto]
Forces 10 Mbps operation
Forces 100 Mbps operation
Forces 1000 Mbps operation
Port automatically detects the speed it should run based on the
port at the other end of the link.Autonegotiation is a requirement
for using 1000BASE-T[3] according to the standard.
RFController(config-if)#speed auto
RFController(config-if)#
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01