Permit - Brocade Communications Systems RFS4000 Cli Reference Manual

permit

MAC Extended ACL config commands
Specifies packets to forward
NOTE
Use a decimal value representation of ethertypes to implement permit/deny/mark designations for
a packet. An Extended MAC ACL provides the hexadecimal values for each listed ethertype. The
controller supports all ethertypes. Use the decimal equivalent of the ethertype listed in the CLI or
any other type of ethertype.
Supported in the following platforms:
•
•
•
Syntax
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Mobility RFS4000 Controller
Mobility RFS6000 Controller
Mobility RFS7000 Controller
permit [icmp|ip|tcp|upd]
permit icmp [<source-IP/Mask>|any|host <IP>] [<dest-IP/
Mask>|any|host <IP>] {<ICMP-type> {<ICMP-code>}} {log}
{rule-precedence <1-5000>]}
permit ip [<source-IP/mask>|any|host <ip>] [<dest-IP/Mask>|any|host <ip>]
{log} {rule-precedence <1-5000>}
permit [tcp|udp] [<source-IP/Mask>|any|host <IP>] {eq
<source-port>|range <starting-source-port>
<ending-sourceport>}[<dest-IP/Mask|any|host <IP>] {eq <source-port>} {range
<starting-source-port>
<ending-source-port>} {log} {rule-precedence <1-5000>}
MAC Extended ACL config commands
16
499