Brocade Communications Systems RFS4000 Cli Reference Manual page 570

19
Radius configuration commands
rad-user
Radius configuration commands
Adds an existing RADIUS user to this group. If the RADIUS user is not available in the Onboard
RADIUS server's database, create a new RADIUS user using the
the
(config-radsrv)
For more information, see
NOTE
It is strictly recommended to set hotspot simultaneous-users to 1 for corresponding WLAN as guest
user is being assigned access-duration.
Syntax
Parameters
<name>
Example
rate-limit
Radius configuration commands
Sets the rate limit for the RADIUS Server group
Syntax
Parameters
wired-to-wireless
<100-100000>
wireless-to-wired
<100-100000>
Usage Guidelines
Use
applied to the group.
[no] rate-limit [wireless-to-wired]
Example
568
mode.
rad-user on page
rad-user <name>
Existing RADIUS user name
RFController(config-radsrv)#rad-user user1 password user1
RFController(config-radsrv)#group group1
RFController(config-radsrv-group)#rad-user user1
RFController(config-radsrv-group)#
rate-limit [wired-to-wireless|wireless-to-wired ]
<100-100000>
Down link direction from network to wireless client
•
Up link direction from wireless client to network
•
[no] rate-limit [wired-to-wireless|wireless-to-wired]
RFController(config-radsrv-group)#rate-limit wired-to-wireless 100
RFController(config-radsrv-group)#
RFController(config-radsrv-group)#rate-limit wireless-to-wired 1000
580.
<100-100000> – Rate in the range of <100-100000> kbps
<100-100000> – Rate in the range of <100-100000> kbps
sets the rate limit back to unlimited
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
command from within
rad-user
to remove the rate limit
53-1001931-01