Config-Wireless) Executable Mode - Brocade Communications Systems RFS4000 Cli Reference Manual

2
show

(config-wireless) Executable Mode

Displays the (config- wireless) configuration parameters and information
Supported in the following platforms:
•
•
•
Syntax
Parameters (config-wireless) Executable Mode
Example
116
Mobility RFS4000 Controller
Mobility RFS6000 Controller
Mobility RFS7000 Controller
show wireless ap [LIST|config]
show wireless config [<1-1024>|LIST]
show wireless radio [<1-4096>|admission-control|all|
beacon-table|config|monitor-table|statistics|unadopted|
uptime|voice]}
show wireless wlan [config|statistics]
show wireless wlan config [<1-256>|all|enabled]
show wireless wlan statistics <1-256> detail
show wireless ap
[LIST|config]
show wireless radio
[<1-4096>|
admission-control|all|
beacon-table|
config|monitor-table|
statistics|unadopted|
uptime|voice]}
show wireless wlan [config
{all|enabled}| statistics
detail} <1-256>
RFController>show wireless ap
Number of access-points adopted
Available licenses
Clustering enabled
Clustering mode
RFController>
Displays wireless LAN parameters. The following information is
displayed:
LIST– MAC address of a single access-port or a list of indices
(e.g.1-4,10) for detailed information
config [<1-1024>|config] – Displays status of configured
access-point
<1-1024> – A single ap index
LIST – Defines MAC Address of a single access point
Refer show wireless radio configuration parameters given in page
106
Configures wireless LAN related parameters
config [<1-256>|all|enabled] – Configures wlan
<1-256> – Displays wlan index
all – Displays all the configured wlans
enabled – Displays only the currently enabled wlans
statistics detail – Displays wlan statistics
detail <1-256> – Displays wlan statistics in detail
<1-256> – Displays wlan index
: 0
: 0
: N
: primary
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01