unitcast-enable
DHCP Config commands
Enables unicast for DHCP offer and DHCP Ack
Supported in the following platforms:
•
•
•
Syntax
Parameters
Example
Configuring the DHCP server using controller CLI
The controller DHCP configuration is conducted by creating pools and mapping them to L3
interfaces (SVI).
•
•
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Mobility RFS4000 Controller
Mobility RFS6000 Controller
Mobility RFS7000 Controller
unicast-enable
None
RFController(config-dhcp)#unicast-enable
RFController(config-dhcp)#
A Network pool is the pool with "include" ranges. When the network pool is mapped to a L3
interface, DHCP clients requesting IPs from the L3 interface get an IP from the configured
range.
A host pool is the pool used to assign static/fixed IP address to DHCP clients.
Configuring the DHCP server using controller CLI
17
537