Wwan - Brocade Communications Systems RFS4000 Cli Reference Manual

5
Global Configuration commands

wwan

Global Configuration commands
Configures wireless wan interface
Supported in the following platforms:
•
•
NOTE
This command is not supported on the Mobility RFS7000 Controller.
Syntax
Parameters
Example
320
Mobility RFS4000 Controller
Mobility RFS6000 Controller
wwan [apn<STRING>|disable|enable|password<STRING>
|username<STRING>]
apn <STRING>
disable
enable
password <STRING>
username <STRING>
RFController(config)#wwan disable
RFController(config)#
RFController(config)#no wwan apn
RFController(config)#
Enter the access point name provided by the service provider.
<STRING> – A string of up to 25 characters
NOTE: Use this command for countries in Europe. This command
is not valid for other countries.
Disables the wireless wan feature
Enables the wireless wan feature
Enter password provided by the service provider
<STRING> – A string of up to 30 characters
Enter username provided by the service provider
<STRING> – A string of up to 32 characters
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01