Wireless Instance; In This Chapter; Wireless Configuration Commands - Brocade Communications Systems RFS4000 Cli Reference Manual

Wireless Instance

In this chapter

Use the
with the controller.
To navigate to this instance, use the command from the Global Config mode.

Wireless configuration commands

This table summarizes
TABLE 22
Command
aap
admission-control
adopt-unconf-radio
adoption-pref-id
ap
ap-containment
ap-detection
ap-image
ap-ip
ap-standby-attempts-thre
shold
ap-timeout
ap-udp-port
auto-select-channels
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
•
Wireless configuration commands. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 589
(config-wireless)
RFController(config)#wireless
RFController(config-wireless)#
(config-wireless)
Wireless Configuration Commands
Description
Sets Adaptive AP (AAP) related commands
Enable admission control across all radios
Adopts a radio even if its not yet configured. The
default templates can be used for configuration.
Used as a preference identifier for this controller. All
radios configured with this preference identifier are
more likely to be adopted by this controller.
Displays access point related commands
Defines the Rogue AP containment configuration
Defines the AP detection configuration
Defines the path to upload the new image over an
AP
Modifies static IP information for access points
Sets the number of attempts after which the
stand-by controller starts adopting APs
Changes the default inactivity timeout for access
points
Configures the UDP port for AP L3 adoption. Enable
this option in the DHCP Server supporting this
access-point.
Configures the channels that will be used when ACS
or DFS is performed.
instance to configure local RADIUS server parameters associated
commands:
Chapter
20
Ref.
page 592
page 594
page 595
page 596
page 597
page 602
page 603
page 604
page 605
page 607
page 608
page 609
page 610
589