Brocade Communications Systems RFS4000 Cli Reference Manual page 686

20
Wireless configuration commands
Parameters
<1-256>
<wlan-list>
For each of the options <1-256> and <wlan-list> the following commands are available.
80211-extensions
move-command enable
802.11w-mfp optional
required sa-query
aap-proxy-radius enable
realm <realm-name> strip
accounting
[none|radius|syslog]
acl exceed-rate
client-denied-traffic
<0-1000000>
disassociate
add-vlan [<1-4094>|
<vlan-list>]
{limit <1-4094>}
answer-bcast-ess
684
Defines a single WLAN index
Sets a list (1,3,7) or range (3-7) of WLAN indices
Enables support for 802.11 extensions.
•
move-command – Enables support for fast roaming.
•
enable – Enables this extension.
Enables 802.11w Management frame protection settings
•
optional – MFP optional
•
required – MFP required
•
sa-query [max-timeout|retry-timeout] – Enables SA
Query protocol settings
•
max-timeout – Displays maximum timeout
•
retry-timeout – Displays retry timeout
Enables configuring of proxying AAP RADIUS requests.
•
realm <realm-name> – Provide proxy realm name.
•
strip – Strip realm name while proxying requests.
Defines the accounting configuration on this WLAN.
•
none – No accounting performed on this WLAN.
•
radius – Uses RADIUS accounting on this WLAN.
•
syslog – Uses Syslog accounting on this WLAN.
Sets the actions taken based on the ACL configuration.
•
exceed-rate – Action is taken when rate exceeds a set value.
•
client-denied-traffic – The action is to deny traffic to the
Client.
•
<0-1000000> – The rate of packets / second after
exceeding which the traffic from the Client is denied access.
•
disassociate – When enabled, the Client is disassociated.
Instead of starting a new VLAN assignment for given WLAN, this
command adds a VLAN assignment to an existing VLAN
assignment. All prior VLAN settings are retained.
•
[<1-4094>|<vlan-list>] – Sets the VLAN range list
<vlan-list>. It can be either a single index or a list (1,3,7) or
range (3-7).
•
limit – Sets user limits on VLANs to a value in the range
<1-4094> for this WLAN.
NOTE: The [no] form of add-vlan command deletes the
specified VLAN mapping over the specified WLAN range
list.
If the specified mapping does not exist for a particular
WLAN, a "specified vlan does not exists" message
displays.
The delete action continues on remaining VLANs. If all the
VLANs are deleted a default VLAN assignment takes
effect.
Allows this WLAN to respond to probes for broadcast ESS.
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01