Load-Balance - Brocade Communications Systems RFS4000 Cli Reference Manual

load-balance

Wireless configuration commands
Configures the user load balance mode
Supported in the following platforms:
•
•
•
Syntax
Parameters
by-count
by-throughput
Example
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Mobility RFS4000 Controller
Mobility RFS6000 Controller
Mobility RFS7000 Controller
load-balance [by-count|by-throughput]
In load balance by user count, the load on the radio is measured
by the number of clients associated. The desired balance is to
have equal number of clients on the radios in the group. By
default, the load balance is configured for
by-count when the controller boots up with factory default
configuration.
In load balance by radio throughput (threshold 1 Mbps) the load
on the radio is measured by the current average throughput rate.
The desired balance is to have similar wireless traffic on the
radios in the group.
RFController(config-wireless)#load-balance by-throughput
RFController(config-wireless)#
Wireless configuration commands
20
631